:	May 13, 2004

: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

:

If the SRS component is to be replaced, the bar code of the new unit must be recorded.

.

Make the SRS system safe.

.

Remove the headliner.

.

Release the roof opening panel drain tube from the securing clips.

.

Release the tire deflation wiring harness from securing clips.

.

Remove the side air curtain module.   Remove the 8 screws.   Remove the 5 Torx screws.   Disconnect the electrical connector.

.

Install the side air curtain module.   Tighten the Torx screws to 10 Nm (7 lb.ft).   Tighten the screws.   Connect the electrical connector.

.

Secure the tire deflation wiring harness into the clips.

.

Secure the roof opening panel drain tube into the clips.

.

Install the headliner.